Page 7 of 7
Re: When is 2.32e going to full release?
Posted: Fri Jul 03, 2015 10:42 am
by underzone
Billion need the fix the QOS upstream bug in 2.32e. I applied and then removed QOS settings (set QOS to 20000/80000, click apply, then set to 0/0 and click apply again) as per:
http://forum.kitz.co.uk/index.php/topic ... cseen.html
I too gained an extra 1MB throughput upstream.
Re: When is 2.32e going to full release?
Posted: Fri Jul 03, 2015 11:41 am
by billion_fan
underzone wrote:Billion need the fix the QOS upstream bug in 2.32e. I applied and then removed QOS settings (set QOS to 20000/80000, click apply, then set to 0/0 and click apply again) as per:
http://forum.kitz.co.uk/index.php/topic ... cseen.html
I too gained an extra 1MB throughput upstream.
Reported to our engineers
Re: When is 2.32e going to full release?
Posted: Sat Jul 11, 2015 2:56 pm
by Eddman
do you have some where I could send the stats as I have 4 weeks of dslstats showing the different firmwares then the last slow "e" version.
BT Home hub 5 still 3 mb higher than Billion
Phillip
Re: When is 2.32e going to full release?
Posted: Wed Jul 15, 2015 1:29 pm
by joe2419
Hi when is this going to be released as full f/ware t.i.a
Re: When is 2.32e going to full release?
Posted: Wed Jul 15, 2015 3:21 pm
by billion_fan
Eddman wrote:do you have some where I could send the stats as I have 4 weeks of dslstats showing the different firmwares then the last slow "e" version.
BT Home hub 5 still 3 mb higher than Billion
Phillip
Not sure if the stats will help as there are many factors that could effect the line speeds eg environment/line, how the router adjusts to the local exchange, chipset/exchange compatibility etc
Lets wait and see what Broadcom reply about the incorrect attainable rate and take it from there.
Re: When is 2.32e going to full release?
Posted: Wed Jul 15, 2015 3:25 pm
by billion_fan
joe2419 wrote:Hi when is this going to be released as full f/ware t.i.a
Firmware can be found here on our official UK support site
http://www.billion.uk.com/esupport/inde ... -available
Re: When is 2.32e going to full release?
Posted: Wed Jul 15, 2015 4:08 pm
by joe2419
Thanks for this billion.
Re: When is 2.32e going to full release?
Posted: Thu Jul 16, 2015 1:11 am
by Eddman
billion_fan wrote:Eddman wrote:do you have some where I could send the stats as I have 4 weeks of dslstats showing the different firmwares then the last slow "e" version.
BT Home hub 5 still 3 mb higher than Billion
Phillip
Not sure if the stats will help as there are many factors that could effect the line speeds eg environment/line, how the router adjusts to the local exchange, chipset/exchange compatibility etc
Lets wait and see what Broadcom reply about the incorrect attainable rate and take it from there.
Hi
I have had the HH5 B with broadcom chip-set on for over 2 weeks now and the dlm has kicked my speed back to 76mb best it could with with 8800 and last firmware 2.32e was 60mb
So something not right, as both routers using Broadcom Chips Pity as I would have thought Billon better than cheap BT HH 5
This is the speed test :-
http://www.thinkbroadband.com/speedtest ... 3855792945
This is the stats from the HH5
Firmware version: v0.07.03.0814-BT (Type B) Last updated [Unknown]
Board version: 01
VDSL uptime: 1 days, 22:43:26
Data Rate: 17940 / 75318
Maximum Data Rate: 18160 / 76141
Noise Margin: 6.3 / 6.3
Line Attenuation: 0.0 / 20.6
Signal Attenuation: 0.0 / 0.0
maybe in a couple of weeks I might try the 8800 again. but do not want to drop 10mb trying, so will leave well alone,
Until you find out the issue.
Just a foot note G.IMP is not either billion or HH5
P
Re: When is 2.32e going to full release?
Posted: Thu Jul 16, 2015 2:24 pm
by 7800nUser
Could you have an iffy 8800?, as my 8800axl is fine with the 2.32d.dh65 firmware. Here are my stats:-
Code: Select all
Stats recorded 16 Jul 2015 14:22:43
DSLAM/MSAN type: BDCM:0xa485 / v0xa485
Modem/router firmware: AnnexA version - A2pv6F039g1.d24m
DSL mode: VDSL2 Profile 17a
Status: Showtime
Uptime: 1 day 23 hours 18 min 45 sec
Resyncs: 0 (since 16 Jul 2015 14:22:38)
Downstream Upstream
Line attenuation (dB): 15.6 0.0
Signal attenuation (dB): Not monitored
Connection speed (kbps): 79999 19999
SNR margin (dB): 7.3 16.9
Power (dBm): 13.0 6.9
Interleave depth: 16 1
INP: 48.00 0
G.INP: Enabled
RSCorr/RS (%): 0.0196 0.9173
RSUnCorr/RS (%): 0.0000 0.0000
ES/hour: 0 7.76