Anything About Billion For UK Users
http://www.billion.uk.com/forum/
Tested and working here see attached screen shots, based off firmware 2.52.d17 (firmware can be found on the attached link viewtopic.php?f=20&t=12298)DarkSpectrum wrote:I recently purchased a Billion 8900AX-2400 so I can run a dual WAN setup (ADSL & 4G). I would like to route all traffic from one IP on my network through the 4G interface and all other traffic through the ADSL. I have tried policy based routing but it didn't work. I cannot use Interface Grouping because all the wired network is connected to the router via one port/cable. How can I configure this setup?
Are you based in Australia?? (as firmware version 2.52.d21 is for AU market, and hence we Billion UK can't comment on that firmware, we have our own firmware)DarkSpectrum wrote:I agree it should be an easy configuration but it is not working see attached screen shots. I can confirm the PCs IP address is 192.168.1.27. I am on firmware 2.52.d21.
You need to edit your 4G wan settings and untick the 'Dial on demand' option found at the top of the page, this should disable failover, and the 4G connection should connect, once connected you should then be able to route through the 4G interfaceDarkSpectrum wrote:Yes, I am based in Australia? It seems like the 4G connection is up and running:
1. Enabled and tested successfully the failover feature from ADSL to 4G. Failover now disabled.
2. However, no IPv4 in for 4G Status > WAN (see attached)
3. But 4G is listed in Advanced Setup > Routing > Default Gateway (see attached)
4G modem/router is the Netgear AirCard 810s.
Thank you! Worked a treatbillion_fan wrote:You need to edit your 4G wan settings and untick the 'Dial on demand' option found at the top of the page, this should disable failover, and the 4G connection should connect, once connected you should then be able to route through the 4G interface
Can you post a screen capture of error you got when trying to add the rule??DarkSpectrum wrote:Thank you! Worked a treatbillion_fan wrote:You need to edit your 4G wan settings and untick the 'Dial on demand' option found at the top of the page, this should disable failover, and the 4G connection should connect, once connected you should then be able to route through the 4G interface
Is there a way to route all traffic on the 5ghz Wi-Fi through the 4G WAN? I tried a policy routing rule as follows but the Billion advised it could not create the rule:
Policy Name 4G_PC_5GHZ
Source IP 192.168.1.21/27 (DHCP Range starts at 192.168.1.20 so trying to capture .20-.127)
LAN Port wireless-5g (the SSID of the 5ghz Wi-Fi)
WAN 3G/4G LTE
Np, it is pretty generic, unfortunately.billion_fan wrote:Can you post a screen capture of error you got when trying to add the rule??
Strange I was able to add a similar rule here, so it might be a firmware issue.DarkSpectrum wrote:Np, it is pretty generic, unfortunately.billion_fan wrote:Can you post a screen capture of error you got when trying to add the rule??