Firewall Config Page not working
Posted: Fri Jun 08, 2012 1:52 pm
Hi,
I have a strange problem on 1.06g
I can ADD new entries to the firewall web configuration page but then cannot EDIT them afterwards.
In addition, the added settings don't seem to work correctly. I have a virtual server set up on port 80 - this works fine. When, however, I add a rule to forward a different external port (e.g. 5000) to the same server on port 80 internally, that doesn't work.
Is there any way to reset the the firewall configuration from the command line? I don't really want to have to factory reset the whole router again.
Regards, Julian.
I have a strange problem on 1.06g
I can ADD new entries to the firewall web configuration page but then cannot EDIT them afterwards.
In addition, the added settings don't seem to work correctly. I have a virtual server set up on port 80 - this works fine. When, however, I add a rule to forward a different external port (e.g. 5000) to the same server on port 80 internally, that doesn't work.
Is there any way to reset the the firewall configuration from the command line? I don't really want to have to factory reset the whole router again.
Regards, Julian.