Billion UK Forum

Does 2.32d.dm2 support G.IMP? If not, which firmware is best for G.INP but also minimising errors when G.INP is not yet enabled?

I am on an ECI cabinet and it seems G.INP has finally been enabled on these cabinets, although until today I had phyr switched off so have not benefited from it yet.

2.32e seemed to be the cause of a lot of errors on my line and I ended up interleaved to 2400 with banding. 2.32d.dm2 stopped the errors and got the interleaving back to 1, although the banding has remained for the last 2 weeks.

Also, just as a side note, 2.32e seemed to have problems closing ports on UPNP when devices no longer needed them. 2.32d.dm2 gives a reliable open NAT to various devices.

have a look at the following thread

viewtopic.php?f=19&t=3522

Thanks, I even posted on that thread, but missed the post from the guy who had G.INP working on 2.32d.dm2 on page 6!

Any ideas which firmware is best for speed and stability? If not, I'll stick with 2.32d.dm2.

craiga79 wrote:Thanks, I even posted on that thread, but missed the post from the guy who had G.INP working on 2.32d.dm2 on page 6!

Any ideas which firmware is best for speed and stability? If not, I'll stick with 2.32d.dm2.

I would stick to 2.32d.dm2 as its best for your enviroment

I too am on an ECI cab with G.INP enabled, using 8800NL. Can you post a link to 2.32d.dm2 please billion_fan.

underzone wrote:I too am on an ECI cab with G.INP enabled, using 8800NL. Can you post a link to 2.32d.dm2 please billion_fan.

Attached

Is this firmware compatible with SKY or do I need a newer one ?

Rolacka wrote:Is this firmware compatible with SKY or do I need a newer one ?

Its compatible with Sky

IP over Ethernet with client ID for VDSL

PPPOA for ADSL

Great. Thanks for the quick reply

Many thanks