7402NX CLI

Discussion for BiPAC 7402 series: 7402, 7402G, 7402X, 7402GX, 7402NX..etc
Post Reply
art15t
Posts: 2
Joined: Mon Feb 10, 2014 1:59 pm

7402NX CLI

Post by art15t » Wed Feb 12, 2014 2:15 pm

Well I found these:

CLI_Manual_ISOS8'2.pdf & BIPAC-5100_CLI_Reference_Manual.pdf

of which CLI_Manual_ISOS8'2.pdf seems to be pretty close to the commands available when I telnet onto the router but I have to say is not very friendly in comparison to a Cisco or Draytek. I'm looking to temporarily open the remote web access via a passthrough telnet session so I can change a few settings in the http GUI that I also can't find in the CLI manuals or just poking around the available commands. Best shot I got was:

admin> webserver set managementip [my_remote_ip] mask 255.255.255.255
admin> system config save
admin> system restart

When I try from my remote I get no response but when I check the settings via telnet again they look good to go

Any you guys got the correct way to do this via CLI ....maybe I also need to add or remove a firewall rule!

Post Reply