8800NL web gui - latest firmware

[maxed68]

I have a Billion 8800NL R2 using the latest firmware 2.52.d10.
The web gui is very unstable, it only seems to allow logins after a power reset.

this is wired or wireless with various different browsers.

Any ideas ?

[billion_fan]

I have a Billion 8800NL R2 using the latest firmware 2.52.d10.
The web gui is very unstable, it only seems to allow logins after a power reset.

this is wired or wireless with various different browsers.

Any ideas ?

When you performed the upgrade did you reset back to factory default settings and manually reconfigure the device from scratch??

[maxed68]

No good point, I didn't really have a config in it when I upgraded the FW.
just a few parameters I kept, from the settings boxes in the previous FW.

the config was built up once the new FW was on, if your saying blank the box and rebuild the config I can.

Is this a know issue ?

[billion_fan]

No good point, I didn't really have a config in it when I upgraded the FW.
just a few parameters I kept, from the settings boxes in the previous FW.

the config was built up once the new FW was on, if your saying blank the box and rebuild the config I can.

Is this a know issue ?

Not that I am aware of.

1. Reset the device and manually reconfigure the device through the web gui, don't import edited configs
2.I think it will good to perform a isolation test, one device connected via Ethernet directly and see if you can access the web gui

[maxed68]

Good Call
That's fixed it, reset to factory and rebuild the config.

web gui now responds every time.

Thanks