Bipac 7800N 1.06g Firmware

[Tomken]

Need the 1.06fdc back.

Just upgraded to 1.06g and my latency has increased by 11ms.

I'm always dubious about betas and looks like I was right about this one but because of the favourable reviews, succumbed against my better judgement.

Is there a link on the forum for the predcessor to this one ?

[AndyCap]

Need the 1.06fdc back.

Is there a link on the forum for the predcessor to this one ?

Bipac 7800N Firmware 1.06f.dc1

[sberest]

I have just ordered this router

Does it matter which port I plug the RJ45 cable into from the BT Box?

Cheers

[billion_fan]

I have just ordered this router

Does it matter which port I plug the RJ45 cable into from the BT Box?

Cheers

If you are using ADSL then you can use any of the 5 ports, (the EWAN port will only connect to 100mbps)

If you are using a fibre connection then you can only use LAN ports 1-4, as the EWAN will be used to connect to your fibre modem

[sparkister]

This fixed the wireless problem i was having but now i connect but get no data through.

[billion_fan]

This fixed the wireless problem i was having but now i connect but get no data through.

Do you mean the firmware has fixed your wireless issue?

[madhatter]

Any update on new firmware for this router.

[billion_fan]

Any update on new firmware for this router.

The latest firmware is 1.06h.dt2 found on the below link

viewtopic.php?f=17&t=1486

This firmware resolves the blank the DHCP table and virtual server crash issue.

[gearcam]

Hi
Sorry for what may be a stupid question in this forum.
My ISP is Sky I have ordered a 7800N and want to set up to connect straight to Sky as the sky Wi-Fi is crap.

I can see the set up help that looks pretty straight forward.
But what do I put in for username|passwork where do I get these from ?

I do have wireshark V1.12.3 and can get it to run but need to know how to get this info ?

is this the correct firmware for Sky ?
UKBillion7800NV6_1.06h.dt2.afw

Thanks Steve

[billion_fan]

Hi
Sorry for what may be a stupid question in this forum.
My ISP is Sky I have ordered a 7800N and want to set up to connect straight to Sky as the sky Wi-Fi is crap.

I can see the set up help that looks pretty straight forward.
But what do I put in for username|passwork where do I get these from ?

I do have wireshark V1.12.3 and can get it to run but need to know how to get this info ?

is this the correct firmware for Sky ?
UKBillion7800NV6_1.06h.dt2.afw

Thanks Steve

1.06h.dt2 is fine for Sky, you will need to extract your current sky username and password from your current sky equipment, you might have to google this procedure or check the skyuser forums