Page 1 of 1

Cannot access 3100SN

Posted: Tue Mar 11, 2014 6:09 pm
by ChrisMK
Hi
This has been sat on a shelf for some time though I did get it set up OK when first bought well over a year ago.
I have reset the device using the button and observed the wlan light flashing.

I have ensured the network adapter settings on the laptop are in the advised range.
I enter 192.168.1.253 into the browser and it cannot display the page.
I can't ping the address either.
Similarly from my desktop machine.

I presume it is faulty?

Re: Cannot access 3100SN

Posted: Wed Mar 12, 2014 9:30 am
by billion_fan
How is the device connected to the network?? eg WDS, AP Client mode, or hard wired connection to the router/network??

I would suggest you plug your PC directly to the 3100SN, set a static IP to your LAN card, in the range of 192.168.1.x and then login using the http://192.168.1.253.

If this fails and you still are unable to ping the device, reset the device again, using the reset pin hole located next to the ethernet jack, press and hold the reset button in for 10 seconds, the WLAN light should turn off (after around 20 seconds this indicates the device is resetting), once it comes back on, try and ping 192.168.1.253 again.

Re: Cannot access 3100SN

Posted: Wed Mar 12, 2014 11:23 am
by ChrisMK
Thank you!
I made the mistake of following the manual regarding the reset switch.
It needs longer.

Once connected it kept dropping out after a couple of minutes.
I took the plunge and updated the firmware and all seems OK.

Now the fun really starts!

Re: Cannot access 3100SN

Posted: Wed Mar 12, 2014 1:48 pm
by billion_fan
ChrisMK wrote:Thank you!
I made the mistake of following the manual regarding the reset switch.
It needs longer.

Once connected it kept dropping out after a couple of minutes.
I took the plunge and updated the firmware and all seems OK.

Now the fun really starts!
Great news, now you can use one of the three setup methods listed below

AP client setup (link below)

http://www.billion.uk.com/esupport/inde ... s-aprouter

WDS setup (link below)

http://www.billion.uk.com/esupport/inde ... /305/3/nsn

Or hard wire a connection from your network to the Bipac 3100SN

Re: Cannot access 3100SN

Posted: Wed Mar 12, 2014 2:13 pm
by ChrisMK
Astonishing.
Where were you a couple of years ago when I last dug this device out!
It's just taken me a minute to 'connect' it to my Netgear 4000.

Many thanks. Much appreciated.