8800axl port forwarding

[glaker]

Hi,
Trying to port forward 37777 to 192.168.1.108 without any success when I test the port I keep being told its not open? could someone please provide a simple step guide I've I tried following the manual without success.
Kind Regards
Alan

[billion_fan]

Try following the attached screen shot

[underzone]

This may work for you:


CCTV 37777 37777 TCP 37777 37777 192.168.1.108
CCTV 37778 37778 UDP 37778 37778 192.168.1.108

[glaker]

Hi,
Thanks for the reply, I've tried those setting and virtually every other I read the manual and tried and better tried. I've done port forwarding in the post with out an issue I cannot believe I cannot get it to work What an expensive mistake this is turning out to be! I've tried the web site canyouseeme and it says the ports aren't open? and advise would be greatly appreciated.
Kind regards
Alan

[billion_fan]

Hi,
Thanks for the reply, I've tried those setting and virtually every other I read the manual and tried and better tried. I've done port forwarding in the post with out an issue I cannot believe I cannot get it to work What an expensive mistake this is turning out to be! I've tried the web site canyouseeme and it says the ports aren't open? and advise would be greatly appreciated.
Kind regards
Alan

Can you post a screen shot of the rules you have already added??

Also can you confirm that you can connect to the device locally?? eg 192.168.108:37777

[glaker]

Hi,
Yes I can access internally 192.168.1.108:37777

SH1.png

SS2.png

SS3.png

Regards
Alan

[billion_fan]

Remove the firewall rules, they are not needed. (as these are set incorrectly)

Once removed test the ports again, it seems the ports are already opened via UPNP so it should be working.

[glaker]

Hi,
Thanks for the reply, I've removed the firewall rules but still no luck, the port forwarding was setup automatically when I flashed version e of the firmware, should I be able to see open ports using the web site 'canyouseeme' ? as I cant I checked the logs and the dns seems to be updating OK (Jun 10 18:08:42 user info syslog: ddnsd: glaker.servepics.com (ptm0.1) IP has changed from (null) to 80.43.95.79) I'm just very confused and a tad disappointed, any other suggestions will be greatly received.
Regards
Alan

[underzone]

Have you set up dyndns or noip to access your network remotely?

[glaker]

Hi,
Yes thats correct
Regards
Alan