Page 1 of 2
8800axl port forwarding
Posted: Mon Jun 01, 2015 5:43 pm
by glaker
Hi,
Trying to port forward 37777 to 192.168.1.108 without any success when I test the port I keep being told its not open? could someone please provide a simple step guide I've I tried following the manual without success.
Kind Regards
Alan
Re: 8800axl port forwarding
Posted: Fri Jun 05, 2015 10:10 am
by billion_fan
Try following the attached screen shot
Re: 8800axl port forwarding
Posted: Fri Jun 05, 2015 6:36 pm
by underzone
This may work for you:
CCTV 37777 37777 TCP 37777 37777 192.168.1.108
CCTV 37778 37778 UDP 37778 37778 192.168.1.108
Re: 8800axl port forwarding
Posted: Mon Jun 08, 2015 7:35 pm
by glaker
Hi,
Thanks for the reply, I've tried those setting and virtually every other I read the manual and tried and better tried. I've done port forwarding in the post with out an issue I cannot believe I cannot get it to work What an expensive mistake this is turning out to be! I've tried the web site canyouseeme and it says the ports aren't open? and advise would be greatly appreciated.
Kind regards
Alan
Re: 8800axl port forwarding
Posted: Mon Jun 08, 2015 7:43 pm
by billion_fan
glaker wrote:Hi,
Thanks for the reply, I've tried those setting and virtually every other I read the manual and tried and better tried. I've done port forwarding in the post with out an issue I cannot believe I cannot get it to work What an expensive mistake this is turning out to be! I've tried the web site canyouseeme and it says the ports aren't open? and advise would be greatly appreciated.
Kind regards
Alan
Can you post a screen shot of the rules you have already added??
Also can you confirm that you can connect to the device locally?? eg 192.168.108:37777
Re: 8800axl port forwarding
Posted: Mon Jun 08, 2015 8:51 pm
by glaker
Hi,
Yes I can access internally 192.168.1.108:37777
SH1.png
SS2.png
SS3.png
Regards
Alan
Re: 8800axl port forwarding
Posted: Wed Jun 10, 2015 9:42 am
by billion_fan
Remove the firewall rules, they are not needed. (as these are set incorrectly)
Once removed test the ports again, it seems the ports are already opened via UPNP so it should be working.
Re: 8800axl port forwarding
Posted: Wed Jun 10, 2015 8:20 pm
by glaker
Hi,
Thanks for the reply, I've removed the firewall rules but still no luck, the port forwarding was setup automatically when I flashed version e of the firmware, should I be able to see open ports using the web site 'canyouseeme' ? as I cant I checked the logs and the dns seems to be updating OK (Jun 10 18:08:42 user info syslog: ddnsd: glaker.servepics.com (ptm0.1) IP has changed from (null) to 80.43.95.79) I'm just very confused and a tad disappointed, any other suggestions will be greatly received.
Regards
Alan
Re: 8800axl port forwarding
Posted: Wed Jun 10, 2015 8:33 pm
by underzone
Have you set up dyndns or noip to access your network remotely?
Re: 8800axl port forwarding
Posted: Thu Jun 11, 2015 9:03 am
by glaker
Hi,
Yes thats correct
Regards
Alan